Same-Day Dryer Repair in Toronto & GTA

Clothes come out damp or cold no matter how long the cycle runs? A failed heating element, blown thermal fuse, or faulty thermostat is usually the culprit.

• Clothes still wet after full cycle
• Drum spins but no heat produced
• Gas dryer: pilot or igniter failure

Taking two or three cycles to dry one load wastes energy and your time. Restricted airflow, a clogged vent, or a weak heating element are common causes.

• Laundry still damp after 90+ minutes
• Machine feels hot on the outside
• Lint trap fills unusually fast

If the motor runs but the drum stays still — or nothing moves at all — a broken belt, worn drum bearing, or seized idler pulley is likely the cause.

• You hear a hum but no rotation
• Belt snapped or visibly damaged
• Drum hard to turn by hand

Banging, squealing, rumbling, or thumping during a cycle signal worn drum support rollers, a loose blower wheel, or foreign objects caught in the drum.

• Squealing or grinding when spinning
• Thumping or banging sounds
• Rattling from inside the drum

A burning odour or flashing error code means you should stop the dryer immediately. Lint build-up near the heating element, faulty wiring, or a control board fault can be fire hazards.

• Burning plastic or rubber smell
• Error codes on digital display
• Dryer shuts off mid-cycle

A broken door latch prevents the dryer from starting, while a worn door seal lets heat escape — dramatically reducing efficiency and extending drying time.

• Door won't stay closed or latch
• Dryer won't start at all
• Heat escaping around the door edge